Instructions

Bike On The Ledge #1 mounting instructions

Bike On The Ledge #2 mounting instructions:

1) Select a section of a load bearing/masonry wall (not hollow or gypsum). Before drilling or putting a screw into a wall, be sure you've checked what's behind it with a pipe, cable and stud detector.
2) Place the bike hanger against the wall where you would like it mounted using a spirit level
3) Keeping the hanger against the wall (with the spirit level) place you hand inside the hanger and mark the screw holes on the wall with a pen.
4) Remove the hanger to check the three screw holes are marked correctly on the wall
5) Drill three holes where you've marked on the wall. Make sure to drill perpendicularly into the wall
6) Insert the plugs into the three holes
7) Place the bike hanger back into position against the wall and using a screw driver, screw the screws tightly into the plugs. 

Bike On The Ledge #3 mounting instructions:

1) Select a section of a load bearing/masonry wall (not hollow or gypsum). Before drilling or putting a screw into a wall, be sure you've checked what's behind it with a pipe, cable and stud detector.
2) Find the two points under your bike's frame where you'd like the poles positioned
3) Mark these two points on the wall using a spirit level
4) Drill two holes where you've marked on the wall. Make sure to drill perpendicularly into the wall.
5) Insert the plugs into the two holes.
6) Screw the poles tightly into the plugs in the wall. Some strength in required.